Sungrow launches 256 kWh/m² PowerStack 3.0 storage for C&I sites

Launch stage screen showing PowerStack 3.0 storage cabinets before an audience in Hefei.
PowerStack 3.0 series presented by Sungrow at GEPS 2026 in Hefei, China.Image Source: Sungrow
Published on: 

Executive summary

A new series of battery storage for commercial and industrial sites, PowerStack 3.0, has been launched by Sungrow at the Global Energy Pioneer Summit 2026 in Hefei, China. Each cabinet has been fitted with a dock that takes one of four modules, so that the same product may be set up for standalone, PV-plus-storage, charging or microgrid sites.

Sungrow, a China-based maker of PV inverters and energy storage systems, has launched PowerStack 3.0, a new series of battery storage for commercial and industrial (C&I) sites. It was presented for the global market on November 11, at the Global Energy Pioneer Summit (GEPS) 2026 in Hefei, China.

The series is built around a dock, and one of four modules is fitted into it to suit the site. For a standalone site, PCS power modules are combined so that one cabinet gives either two or four hours of discharge, and fewer variants then have to be kept in stock. With the PV-storage module, the storage PCS also converts the PV power, and a DC-coupled plant can be built without a separate inverter. The charging module puts EV chargers on the same DC link. The microgrid module, for its part, keeps critical loads supplied in an outage and switches to off-grid operation in 0 ms, without a separate static transfer switch (STS) cabinet.

Each of these sites is to be planned and run with Bubbly, an AI assistant developed by Sungrow. The company has said that the assistant can prepare a design proposal from satellite images in about 30 seconds, and that it can complete commissioning in 3 minutes. In service, it dispatches the battery against PV and load forecasts, and Sungrow has put the gain in returns at more than 12% over a plain self-consumption mode. For a 10 MWh plant, a fault report can be had in about 1 minute.

The hardware, too, has been changed to hold more energy on less ground. The energy density reaches 256 kWh/m², up to 20 units can be connected in parallel, and a 5 MWh plant needs 43% less floor space than with the previous generation. A silicon carbide (SiC) PCS of Sungrow's own design reaches a conversion efficiency of 99.2%, and, with a 684 Ah stacked cell, its round-trip efficiency is over 92%. Its ratings are IP55 for ingress and C5 for corrosion, it runs from -30°C to 50°C, and its protection is made up of three levels of fuses and four layers of fire safety.

Today, we have entered the 3.0 era - the scenario-driven era. Sungrow brings you more than a new product. We bring a complete ecosystem solution: designed for every scenario, powered by intelligence and connected across the entire value chain.

Dr. Cao Wei, General Manager of Sungrow's C&I ESS Product Line

Earlier PowerStack models were shown in other markets this year. Sungrow's PowerStack 255CS system was displayed at Solar & Storage Live Vietnam 2026 in July, and in October Sungrow India showed the 257 kWh PowerStack ST255CS at REI Expo 2026 in Greater Noida, India.